Model Deformation Measurements

MDM setup-here in F1 test section

The real-time model deformation measurement (MDM) and positioning is important information during wind tunnel tests.

The model is equipped with adhesive markers, essentially on its wings.

The calibration phase of the MDM system used a reference test pattern. It is possible to define all the calibration parameters of the two cameras: relative position, viewing angles, focus and distortions.

Using the method of processing based on epipolar geometry (the application of projective geometry techniques), the three marker coordinates were deduced from any image pair.

This technique is available is F1, S1MA and S2MA in industrial conditions.

Model markers applied to the wing upper surface model
 
MDM - Typical results
MDM - Typical results